Point of Sale Setup - Pin Pad Tab

Editor's Note: Although the framework of supporting Pin Pads in place, the functionality is not considered to be supported at this time. It will be available for beta testing in the near future. 11/11/10

Go to the Main Menu>Maintenance Menu>Setup Functions tab>Point of Sale Setup button. The Point of Sale Setup dialog box opens. To make changes, click the Edit button. When you are in edit mode, click the Save button to save your changes or click the Cancel button to exit edit mode without saving your changes.

The Pin Pad tab is used to configure the Pin Pad hardware. You can configure the settings for all workstations provided the Pin Pad hardware and settings are EXACTLY the same on all of your POS workstations, or you can configure each workstation separately.

To configure each workstation separately, click in the Configure Single Workstation checkbox and then select the name of the workstation you wish to configure from the Select Workstation drop down list. Note: If you change the workstation name before clicking the Apply Changes button or the Save button, your changes are lost.

To configure the settings for all of your POS workstations, do not click in the Configure Single Workstation checkbox.

Enable PinPad Use - If you wish to use a Pin Pad, click in the Enable PinPad Use checkbox.

PinPad Model - Select the specific model of the Pin Pad from the PinPad Model drop down list. Note: If your Pin Pad model is not listed, contact Stone Edge Technologies.

COM Port Settings

Enter the number of the COM Port to which the Pin Pad is assigned. Consult the manufacturer’s documentation for the proper serial port settings.

Key Management Settings

Type - Select the key type used by the Pin Pad. Consult the manufacturer’s documentation for this information.

Key - If the Type is set to Master Session, enter the encryption key used by the Pin Pad. If the Type is set to DUKPT, leave this field blank.

Test - To test the Pin Pad settings, enter some text in the Display field and click the Test button. Note: The test may not work until after you have configured and saved all other settings.